PCV Hose ASSY No. 2

Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Note.>
Remove the oil catch tank. <Ref. to REMOVAL , Oil Catch Tank.>
Remove the clamp cover.

Fig 1: Locating PCV Hose Assy No. 2 Clamp Cover
Courtesy of SUBARU OF AMERICA, INC.
Break the clamp, and remove the PCV hose assembly No. 2 from the oil catch tank.

Fig 2: Locating PCV Hose Assembly No. 2 Clamp
Courtesy of SUBARU OF AMERICA, INC.
Break the clamp, and remove the blow-by diagnosis connector from the PCV hose No. 2.
Install the blow-by diagnosis connector to the PCV hose No. 2, and install the clamp using the Clamp pincer (14100134).
NOTE: Use a new clamp.

Fig 3: Removing Blow-By Diagnosis Connector From PCV Hose No. 2
Courtesy of SUBARU OF AMERICA, INC.
Install the PCV hose assembly No. 2 to the oil catch tank, and install the clamp using the Clamp pincer (14100134).
NOTE: Use a new clamp.

Fig 4: Installing Clamp Using Clamp Pincer (14100134)
Courtesy of SUBARU OF AMERICA, INC.
Install the clamp cover.
CAUTION: Be careful not to allow the lower part of the clamp cover to ride over the PCV hose assembly No. 2.

Fig 5: Caution For Installing Clamp Cover
Courtesy of SUBARU OF AMERICA, INC.
Install the oil catch tank. <Ref. to INSTALLATION , Oil Catch Tank.>
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Note.>