LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Outback 2.5i >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) (Service Information) >> Sunload Sensor (Auto A/C Model) >> Removal

Sunload Sensor (Auto A/C Model): Removal

  1. Disconnect the ground terminal from battery sensor. Ref. to BATTERY
    NOTE: Repair Contents.
  2. Remove the trim panel - front pillar UPR. Ref. to REMOVAL , Upper Inner Trim.
  3. Release the clips and claws, then detach the grille speaker side. Ref. to TWEETER , REMOVAL, Front Speaker.
  4. Remove the sunload sensor.
    1. Release the claws of the grille - front defroster.
      CAUTION:
      • Secure minimum space for performing the operation. Do not remove the grille - front defroster. If the grille - front defroster is removed, it cannot be reinstalled unless the instrument panel is removed.
      • Be careful not to damage the sensor and interior trim.
      Fig 1: Identifying Front Defroster Grille Claws
      G10276829Courtesy of SUBARU OF AMERICA, INC.
    2. Release the claws, and then pull out the sunload sensor from the grille - front defroster.
    3. Disconnect the connector and remove the sunload sensor.
    Fig 2: Removing Sunload Sensor
    G10276830Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals