LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Outback 2.5i >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Switches and Harness >> Removal >> Trip Reset Switch

Trip Reset Switch

  1. Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
  2. Remove the cover assembly - instrument panel LWR driver. <Ref. to REMOVAL , Instrument Panel Lower Cover.>
  3. Remove the visor assembly - lower.
    1. Release the clips and claws.
    2. Disconnect the connector and remove the visor assembly - lower.
    CAUTION:
    • Being careful not to damage the visor assembly - lower, slowly remove the clips and claws one by one from the right and left edges of visor assembly - lower.
    • When using a clip remover, wrap it with protective tape or cloth.
    Fig 1: Removing Lower Visor Assembly Connector
    G10272985Courtesy of SUBARU OF AMERICA, INC.
  4. Release the claws, and remove the switch assembly - trip reset.
Fig 2: Trip Reset Switch Assembly Claws Location
G10272779Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals