Glove Box: Removal

NOTE: Refer to "Security and Locks" section for key cylinder replacement. <Ref. to GLOVE BOX LID , REPLACEMENT, Key Lock Cylinders.>

Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Remove the pocket assembly.
1. Remove the damper COMPL - pocket.
2. Release the stoppers and remove the pocket assembly by pulling it toward you.
Fig 1: Locating Stopper Of Pocket Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the cover side sill - front and the front cover - side sill. <Ref. to REMOVAL , Lower Inner Trim.>
Remove the back panel - pocket.
1. Release the hook, and remove the under cover assembly - passenger.
  
  Fig 2: Releasing Hook Under Cover Assembly - Passenger
  Courtesy of SUBARU OF AMERICA, INC.
2. Remove the clips, and remove the cover - instrument panel side RH.
3. Release the clips, and remove the ornament - panel assembly passenger.
  
  Fig 3: Locating Ornament - Panel Assembly Passenger Clips
  Courtesy of SUBARU OF AMERICA, INC.
4. Disconnect the glove box light LED connector.
5. Remove the screws, claws and harness clamp, then remove the back panel - pocket.
Fig 4: Disconnecting Glove Box Light LED Connector
Courtesy of SUBARU OF AMERICA, INC.