Light Control Sensor: Removal

Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Remove the trim panel - front pillar UPR. <Ref. to REMOVAL , Upper Inner Trim.>
Release the clips and claws, then detach the grille speaker side. <Ref. to TWEETER , REMOVAL, Front Speaker.>
Remove the sensor - automatic light.
1. Release the claws of the grille - front defroster.
  CAUTION:
  - Secure minimum space for performing the operation. Do not remove the grille - front defroster. If the grille - front defroster is removed, it cannot be reinstalled unless the instrument panel is removed.
  - Be careful not to damage the sensor and interior trim.
  Fig 1: Claws Of Grille - Front Defroster
  Courtesy of SUBARU OF AMERICA, INC.
2. Release the claws, and then pull out the sensor - automatic light from the grille - front defroster.
3. Disconnect the connector and remove the sensor - automatic light.
Fig 2: Removing Sensor - Automatic Light With Connector
Courtesy of SUBARU OF AMERICA, INC.