LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 3.6R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Cooling System (H4DO)) >> Radiator Fan and Fan Motor Assembly >> Installation

Radiator Fan and Fan Motor Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the radiator fan & fan motor assembly, and install the radiator fan & fan motor assembly to the claw on the radiator upper side.
  2. Connect the connector to the radiator main fan motor, as well as the connector to the radiator sub fan motor.
  3. Install the reservoir tank. Ref. to INSTALLATION , Reservoir Tank.
  4. Connect the radiator inlet hose to the radiator.
  5. Install the air intake duct. Ref. to INSTALLATION , Air Intake Duct.
  6. Lift up the vehicle.
  7. Install the under cover. Ref. to INSTALLATION , Front Under Cover.
  8. Lower the vehicle.
  9. Connect the ground terminal to battery sensor. Ref. to BATTERY
    NOTE: Repair Contents.
  10. Fill engine coolant. Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.
scientia non olet · About LEMON Manuals