LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 3.6R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Cooling System (H4DO)) >> Active Grille Shutter >> Installation

Active Grille Shutter: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the ambient sensor.
  2. Install the active grille shutter using the bolts securing the active grille shutter.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  3. Connect the connector to the active grille shutter actuator.
  4. Connect the connector to the ambient sensor.
  5. Install the front bumper. Ref. to INSTALLATION , Front Bumper.
  6. Connect the ground terminal to battery sensor. Ref. to BATTERY
    NOTE: Repair Contents.
  7. When the active grille shutter has been replaced, perform the calibration (execute the system operation check for ACTGS control). Ref. to OPERATION , Active Test.
scientia non olet · About LEMON Manuals