Oil Control Solenoid: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causing a fire.

Disconnect the ground terminal from battery sensor. Ref. to BATTERY
Remove the air intake duct. (RH side only) Ref. to REMOVAL , Air Intake Duct.
Disconnect the connector (A) from the intake oil control solenoid, and remove the intake oil control solenoid from the chain cover.

RH side

Fig 1: Locating Intake Oil Control Solenoid Connector And Bolt (RH Side)
Courtesy of SUBARU OF AMERICA, INC.
LH side

Fig 2: Locating Intake Oil Control Solenoid Connector And Bolt (LH Side)

Courtesy of SUBARU OF AMERICA, INC.