LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 3.6R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Starting System & Charging System (H4DO)) >> Generator >> Inspection >> Stator Coil

Stator Coil

WARNING: This page is about a different variant/trim than selected.
  1. Continuity test

    Inspect the continuity between the stator coil terminals. If continuity is not as shown in the table, replace the stator coil.

    Fig 1: Stator Coil Terminals Continuity Chart
    G11566981Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Checking Continuity Between Stator Coil Terminals
    G07665198Courtesy of SUBARU OF AMERICA, INC.
  2. Insulation test

    Inspect the continuity between the stator coil stator core and lead wire terminals. If there is continuity, replace the stator coil because the stator coil is grounded.

Fig 3: Checking Continuity Between Stator Coil, Stator Core And Lead Wire Terminals
G07665199Courtesy of SUBARU OF AMERICA, INC.