When Switched To X Mode, "X" Mode Display In Combination Meter Flashes In After Approx. 5 Seconds
WARNING: This page is about a different variant/trim than selected.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC . | Is DTC displayed? | Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)" concerning the respective units. | Go to step 2 . |
| 2 CHECK COMBINATION METER AND CLOCK DISPLAY
. Check for abnormal indication other than "X" blinking. Examples:
NOTE:
The system enters into fail mode with ignition ON and engine OFF.
|
Is there any abnormal indication other than "X" blinking? | For the diagnostic procedure, refer to LAN section. <Ref. to BASIC DIAGNOSTIC PROCEDURE .> | Go to step 3 . |
| 3 CHECK ECM AND COMBINATION METER . | Is the part number of ECM and combination meter correct? | Replace the meter case assembly. <Ref. to COMBINATION METER .> | Replace ECM or meter case assembly with the one with the correct part number. <Ref. to ENGINE CONTROL MODULE (ECM) .> <Ref. to COMBINATION METER .> |