Pressing X Mode Switch Does Not Change The X Mode Display In The Combination Meter And Mode Does Not Switch To X Mode

WARNING: This page is about a different variant/trim than selected.

WIRING DIAGRAM:

<Ref. to WIRING DIAGRAM , CVT Control System.>

Fig 1: X Mode Switch Wiring Diagram

G10275060

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK X MODE SWITCH . Turn the ignition switch to OFF. Disconnect the connector from the combination meter. Measure the resistance when the X mode switch is operated. Connector & terminal (i10) No. 37 - Chassis ground:	Does the resistance change as below? 1 MΩ or more → less than 10 Ω	Go to step 5 .	Go to step 2 .
2 CHECK HARNESS BETWEEN COMBINATION METER AND X MODE SWITCH CONNECTOR . Measure the resistance of harness between combination meter and X mode switch connector. Connector & terminal (i10) No. 37 - (i70) No. 1:	Is the resistance less than 10 Ω?	Go to step 3 .	Repair the harness and connector. NOTE: In this case, repair the following item: Open circuit in harness between combination meter and X mode switch connector Poor contact of connector
3 CHECK HARNESS BETWEEN COMBINATION METER AND X MODE SWITCH CONNECTOR . Measure the resistance of harness between X mode switch connector and chassis ground. Connector & terminal (i70) No. 1 - Chassis ground:	Is the resistance 1 MΩ or more?	Go to step 4 .	Repair the short circuit to ground in harness between combination meter and X mode switch connector.
4 CHECK HARNESS BETWEEN X MODE SWITCH CONNECTOR AND CHASSIS GROUND . Measure the resistance between combination meter and chassis ground. Connector & terminal (i70) No. 4 - Chassis ground:	Is the resistance less than 10 Ω?	Repair the poor contact of X mode switch connector. Replace the X mode switch if faulty. <Ref. to X MODE SWITCH .> <Ref. to X MODE SWITCH .>	Repair the harness and connector. NOTE: In this case, repair the following item: Open circuit in harness between X mode switch connector and chassis ground Poor contact of joint connector
5 RECHECK FAULT . Connect all connectors. Switch to X mode.	Is there any fault?	Repair the poor contact of combination meter. Replace the meter case assembly if defective.	The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.