DTC P05A2: Active Grille Air Shutter "A" Control Circuit/Open: Notes

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition:

Immediately at fault recognition

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to OPERATION , Clear Memory Mode, and Inspection Mode Ref. to PROCEDURE , Inspection Mode.

Step	Check	Yes	No
1 CHECK DTC. Perform the Clear Memory Mode using the Subaru Select Monitor. Ref. to OPERATION , Clear Memory Mode. Turn the ignition switch to OFF, and wait for approx. 30 seconds. Turn the ignition switch to ON. Check for DTC. Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC)	Is P05A2 displayed in current malfunction?	Replace the active grille shutter. Ref. to ACTIVE GRILLE SHUTTER	Using the Subaru Select Monitor, perform the operation check for the active grille shutter to make sure that its open and close operation can be completed properly. NOTE: For detailed operation procedures, refer to the "Active Test". Ref. to ACTIVE TEST