DTC P059A: Active Grille Air Shutter "A" Position Sensor Circuit: Notes

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION:

Immediately at fault recognition

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to OPERATION , Clear Memory Mode, and Inspection Mode Ref. to PROCEDURE , Inspection Mode.

Step	Check	Yes	No
1 CHECK ACTIVE GRILLE SHUTTER. Check the area around the active grille shutter louver, louver link and actuator.	Is there any abnormality such as a foreign matter adhered or pinched and a frost?	Remove the foreign matter from the active grille shutter and go to the next step. Go to step 2.	Go to step 2
2 CHECK ACTIVE GRILLE SHUTTER. Turn the ignition switch to OFF, and wait for approx. 30 seconds. Turn the ignition switch to ON. NOTE: Make sure that the ambient temperature is equal to or higher than 3°C (37.4°F). Start the engine. Three minutes after starting the engine, perform the operation check for the active grille shutter using the Subaru Select Monitor. NOTE: For detailed operation procedures, refer to the "Active Test". Ref. to ACTIVE TEST	Does the open/close operation finish correctly?	Even if DTC is detected, it has returned to a normal condition at this time. NOTE: In this case, it is assumed that the active grille shutter may have temporarily had a foreign matter adhered/pinched or a frost.	Replace the active grille shutter. Ref. to ACTIVE GRILLE SHUTTER