Execution Condition
WARNING: This page is about a different variant/trim than selected.
| Secondary parameters | Execution condition | ||
|---|---|---|---|
| Time when Evaporative Leak Check Module switching valve is closed | < 120000 ms | ||
| Purge control duty ratio | > 0% | ||
| Precondition (Conditions to close the switching valve of Evaporative Leak Check Module intrusively.) |
|||
| Battery voltage | ≥ 10.9 V | ||
| Barometric pressure | ≥ 75.1 kPa (563 mmHg, 22.2 inHg) | ||
| Integrated value of calculated purge airflow since engine start | ≥ Value from Map(1) | ||
| Atmospheric pressure - Intake manifold absolute pressure | ≥ 6.7 kPa (50 mmHg, 2 inHg) | ||
| ((Fuel system status for time) | = Fuel cut | ||
| followed by | ≥ 1000 ms | ||
| Fuel system status) | Fuel cut | ||
| Ambient temperature | ≥ -25 °C (-13 °F) | ||
|
|||
Map
| Ambient temperature °C (°F) | 0 (32) | 10 (50) | 20 (68) | 30 (86) | 40 (104) | 50 (122) |
| Integrated value of calculated purge airflow since engine start g (oz) | 72 (2.54) | 72 (2.54) | 72 (2.54) | 72 (2.54) | 72 (2.54) | 72 (2.54) |