Purge Control Solenoid Valve: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the ground terminal from battery sensor. Ref. to BATTERY
NOTE: Repair Contents.
Remove the bolt securing the purge control solenoid valve onto intake manifold assembly.
NOTE: Hold the purge control solenoid valve unit by hand to prevent it from rotating together.
Disconnect the vacuum hose from the intake manifold assembly, and remove the vacuum hose from the clip (A).

Fig 1: Identifying Vacuum Hose Clip
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the vacuum hose (A) and connector (B) from the purge control solenoid valve, and remove the purge control solenoid valve.

Fig 2: Identifying Purge Control Solenoid Valve Vacuum Hose And Connector
Courtesy of SUBARU OF AMERICA, INC.
Remove the vacuum hose from the purge control solenoid valve.

Fig 3: Identifying Purge Control Solenoid Valve Vacuum Hose

Courtesy of SUBARU OF AMERICA, INC.