LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 3.6R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Emission Control Systems (Aux. Emission Control Devices) (H4DO)) >> Purge Control Solenoid Valve >> Installation

Purge Control Solenoid Valve: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the vacuum hose to the purge control solenoid valve.
    Fig 1: Identifying Purge Control Solenoid Valve Vacuum Hose
    G10262362Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the vacuum hose (A) and connector (B) to the purge control solenoid valve.
    Fig 2: Identifying Purge Control Solenoid Valve Vacuum Hose And Connector
    G10262361Courtesy of SUBARU OF AMERICA, INC.
  3. Install the bolt securing the purge control solenoid valve to the intake manifold assembly.
    NOTE: Hold the purge control solenoid valve unit by hand to prevent it from rotating together.

    Tightening torque: 

    3.4 N.m (0.3 kgf-m, 2.5 ft-lb) 

  4. Secure the vacuum hose to the clip (A), and connect the vacuum hose to the intake manifold assembly.
    Fig 3: Identifying Vacuum Hose Clip
    G10262360Courtesy of SUBARU OF AMERICA, INC.
  5. Connect the ground terminal to battery sensor. Ref. to BATTERY
    NOTE: Repair Contents.
scientia non olet · About LEMON Manuals