PCV Hose: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Do not remove except when the PCV hose is broken.

Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.

Fig 1: Air Intake Boot Clip And Clamps
Courtesy of SUBARU OF AMERICA, INC.
Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.

Fig 2: Removing Air Intake Boot
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the PCV hose A from the intake manifold assembly and the PCV valve, and then remove the PCV hose A.

Fig 3: Identifying PCV Hose A
Courtesy of SUBARU OF AMERICA, INC.
Remove the intake manifold assembly. Ref. to REMOVAL , Intake Manifold Assembly.
Remove the PCV hose B from the PCV connector.

Fig 4: Identifying PCV Hose B

Courtesy of SUBARU OF AMERICA, INC.