EGR Pipe: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.

Fig 1: Air Intake Boot Clip And Clamps
Courtesy of SUBARU OF AMERICA, INC.
Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.

Fig 2: Removing Air Intake Boot
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts securing the throttle body to the intake manifold assembly, and tilt the throttle body to the rear side of vehicle.

Fig 3: Identifying Throttle Body Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts securing the EGR pipe to the intake manifold assembly and EGR control valve, and remove the EGR pipe.

Fig 4: Identifying EGR Pipe Bolts
Courtesy of SUBARU OF AMERICA, INC.