Front Cushion Rubber And Engine Mounting Bracket

WARNING: This page is about a different variant/trim than selected.

Install the engine mounting bracket onto the engine.
Tightening torque:

30 N.m (3.1 kgf-m, 22.1 ft-lb)
Install the front cushion rubber to the front mounting bracket and engine mounting bracket.
Tightening torque:

T1: 25 N.m (2.5 kgf-m, 18.4 ft-lb)

T2: 45 N.m (4.6 kgf-m, 33.2 ft-lb)

Fig 1: Identifying Front Mounting Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the lifting device and wire ropes.

Fig 2: Identifying Engine With Lifting Device And Wire Ropes
Courtesy of SUBARU OF AMERICA, INC.
Remove the ST1 and ST2 from the engine unit.
ST1 18363AA050 BOLT

ST2 18360AA040 HANGER

Fig 3: Identifying ST1 And ST2
Courtesy of SUBARU OF AMERICA, INC.
Install the V-belt cover.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)
Install the air intake boot. Ref. to INSTALLATION , Air Intake Boot.
Install the air intake duct. Ref. to INSTALLATION , Air Intake Duct.
Connect the ground terminal to battery sensor. Ref. to BATTERY , NOTE, Repair Contents.
Set the front hood to the normal position. Ref. to FRONT HOOD DAMPER STAY , NOTE, Repair Contents.
Close the front hood.