Transmission Harness: Inspection
WARNING: This page is about a different variant/trim than selected.
- Visually check the harness and connector for damage or crack.
- Check the harness terminal for rust, disconnection or poor contact.
- Check the continuity between harness terminals and oil temperature sensor.
NOTE:
Refer to WIRING information for transmission harness terminal and oil temperature sensor terminal. Ref. to
WIRING DIAGRAM
, CVT Control System.
Harness continuity standard:
Less than 1 Ω
Oil temperature sensor standard:
Approx. 2.6 kΩ (at 20°C)