Transfer Reduction Driven Gear: Assembly

1. Install the new ball bearing (large) to reduction driven gear using the ST.

   ST 499277100 BUSHING 1-2 INSTALLER

   NOTE:

   • Use a new ball bearing.
   • Install to the splines inside transfer reduction driven gear shaft.
   Fig 1: Installing Ball Bearing (Large)

   Courtesy of SUBARU OF AMERICA, INC.
2. Install the new ball bearing (small) to reduction driven gear.

ST 499277100 BUSHING 1-2 INSTALLER

Fig 2: Installing Ball Bearing (Small)

Courtesy of SUBARU OF AMERICA, INC.