General Tool

WARNING: This page is about a different variant/trim than selected.

TOOL NAME	REMARKS
Circuit tester	Used for measuring resistance, voltage and current.
Thickness gauge	Used for the clearance in reverse brake, transfer clutch and input clutch.
Caliper	Used for measuring the clearance at the parts.
Spring scale	Used for measuring the starting torque of the drive pinion.
TORX® bit T70	Used for removing and installing differential gear oil drain plug.
Straight pin remover	Used for removing and installing the spring pin.
Deep socket	Used for removing and installing the secondary pressure sensor. NOTE: Use Ko-ken 3/8 12-point 27 mm (manufacturer product No. 3305M-27).
Push/pull gauge	Used for measuring clutch clearance.
Angle gauge	Used for installing the hypoid driven gear. Used for installing the drive plate.
Chain sling	Used for removing and installing transmission. Length: 0.8 - 1 m (2.6 - 3.3 ft) Load capacity: 1.2 t (2646 lb) or more Diameter: 6 mm (0.24 in) or 6.3 mm (0.25 in) Chain external width: 23.5 mm (0.93 in) or less Chain internal width: 8.5 mm (0.33 in) or more
Screw shackle	Used for removing and installing transmission. Load capacity: 250 kg (551 lb) or more Use two pieces.
DST-i	Used together with Subaru Select Monitor 4.