Forward Clutch Assembly: Disassembly
WARNING: This page is about a different variant/trim than selected.
- Remove the internal gear assembly.
- Remove the snap ring from the internal gear assembly.
- Remove the thrust gear plate.
- Remove the thrust needle bearing.
- Remove the snap ring.
- Remove the planetary carrier assembly.
- Remove the thrust needle bearing.
- Remove the sun gear.
- Remove the forward clutch hub.
- Remove the washer.
- Remove the thrust needle bearing.
- Remove the retaining plate, drive plate, driven plate and dish plate.
- Using the ST, remove the snap ring.
ST 18762AA001 COMPRESSOR SPECIAL TOOL
- Remove the forward clutch piston retainer.
- Remove the return spring.
- Remove the forward clutch piston by blowing compressed air intermittently from the end of forward clutch drum.