Intake And Exhaust Valve Oil Seal
WARNING: This page is about a different variant/trim than selected.
- For the following, replace the oil seal with a new part.
- When the lip is damaged.
- When the spring is out of the specified position.
- When readjusting the surfaces of valve and valve seat.
- When replacing the valve guide.
- Set the cylinder head on ST1.
- Using the ST2, press in the oil seal.
ST1 18250AA010 CYLINDER HEAD TABLE
ST2 18261AA010 VALVE OIL SEAL GUIDE
NOTE:- Apply engine oil to oil seal before press-fitting.
- When press-fitting the oil seal, do not use a hammer to strike in.