LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Exhaust System (H6DO)) >> Rear Exhaust Pipe >> Installation

Rear Exhaust Pipe: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply a coat of spray type lubricant to the mating area of cushion rubber.
  2. Install the rear exhaust pipe to cushion rubber.
    NOTE: After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.
  3. Install the bolts and self-locking nuts which secure the muffler to the rear exhaust pipe.
    NOTE: Use a new gasket and self-locking nut.

    Tightening torque: 

    48 N.m (4.9 kgf-m, 35.4 ft-lb) 

  4. Install the bolts, springs and nuts securing the front exhaust pipe assembly to the rear exhaust pipe.
    NOTE: Use a new gasket.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb) 

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals