Pulsation Damper RH

WARNING: This page is about a different variant/trim than selected.

Install the pulsation damper RH to the fuel injector pipe RH.
NOTE: Use a new gasket.

Tightening torque:

21.6 N.m (2.2 kgf-m, 15.9 ft-lb)

Fig 1: Locating Pulsation Damper RH
Courtesy of SUBARU OF AMERICA, INC.
Install the fuel pipe protector RH.
Tightening torque:

19 N.m (1.9 kgf-m, 14.0 ft-lb)

Fig 2: Locating Fuel Pipe Protector RH Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake boot. <Ref. to INSTALLATION , Air Intake Boot.>
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Install the collector cover.