LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (Diagnostics) (P000A To P015D) (H6DO)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0068: Map/MAF - Throttle Position Correlation >> Notes

DTC P0068: Map/MAF - Throttle Position Correlation: Notes

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition: 

Detected when two consecutive driving cycles with fault occur.

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to OPERATION , Clear Memory Mode and Inspection Mode Ref. to PROCEDURE , Inspection Mode.
Step Check Yes No
1 CHECK AIR INTAKE SYSTEM.  Are there holes, loose bolts or disconnection of hose on air intake system? Repair the air intake system. Go to step
2 CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR. 
  1. Start the engine and warm up engine until coolant temperature is higher than 75°C (167°F).
  2. Place the select lever in "P" range or "N" range.
  3. Turn the A/C switch to OFF.
  4. Turn all the accessory switches to OFF.
  5. Read the value of «Mani. Absolute Pressure » using the Subaru Select Monitor or a general scan tool.
NOTE:
  • Subaru Select Monitor

    For detailed operation procedures, refer to "Current Data Display For Engine". Ref. to SUBARU SELECT MONITOR

  • General scan tool

    For detailed operation procedures, refer to the general scan tool operation manual.

Is the value in «Mani. Absolute Pressure» 73.3 - 106.6 kPa (550 - 800 mmHg, 21.65 - 31.50 inHg) when the ignition is turned ON, and 20.0 - 46.7 kPa (150 - 350 mmHg, 5.91 - 13.78 inHg) during idling? Go to step Replace the manifold absolute pressure sensor. Ref. to MANIFOLD ABSOLUTE PRESSURE SENSOR
3 CHECK THROTTLE OPENING ANGLE. 
Using the Subaru Select Monitor or a general scan tool, read the value in «Throttle Opening Angle».
NOTE:
  • Subaru Select Monitor

    For detailed operation procedures, refer to "Current Data Display For Engine". Ref. to SUBARU SELECT MONITOR

  • General scan tool

    For detailed operation procedures, refer to the general scan tool operation manual.

Is the value in «Throttle Opening Angle» with the throttle fully closed less than 5%? Go to step Replace the electronic throttle control. Ref. to THROTTLE BODY
4 CHECK THROTTLE OPENING ANGLE.  Is the value in «Throttle Opening Angle» with the throttle fully open 85% or more? Replace the manifold absolute pressure sensor. Ref. to MANIFOLD ABSOLUTE PRESSURE SENSOR Replace the electronic throttle control. Ref. to THROTTLE BODY