DTC P0058: A/F/O2 Heater Control Circuit High Bank 2 Sensor 2: Notes

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to OPERATION , Clear Memory Mode and Inspection Mode Ref. to PROCEDURE , Inspection Mode.

Wiring diagram:

Engine Electrical System Ref. to WIRING DIAGRAM , Engine Electrical System.

Fig 1: Rear Oxygen Sensor Wiring Diagram

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND REAR OXYGEN SENSOR CONNECTOR. Turn the ignition switch to OFF. Measure the voltage between ECM connector and chassis ground. Connector & terminal (E158) No. 11 (+) - Chassis ground (-):	Is the voltage 10 V or more?	Repair the short circuit to power in the harness between ECM connector and rear oxygen sensor connector.	Go to step 2
2 CHECK GROUND CIRCUIT FOR ECM. Disconnect the connector from ECM. Measure the resistance between ECM connector and chassis ground. Connector & terminal (E158) No. 60 - Chassis ground: (E158) No. 61 - Chassis ground: (E158) No. 62 - Chassis ground: (E158) No. 63 - Chassis ground: (E158) No. 64 - Chassis ground: (E158) No. 65 - Chassis ground:	Is the resistance less than 5 Ω?	Repair the poor contact of ECM connector.	Repair the open circuit in harness between ECM connector and engine ground.