DTC P0016: Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A: Notes
WARNING: This page is about a different variant/trim than selected.
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
- Engine stalls.
- Improper idling
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to
OPERATION
, Clear Memory Mode and Inspection Mode Ref. to
PROCEDURE
, Inspection Mode.
| Step | Check | Yes | No |
|---|---|---|---|
1 CHECK CURRENT DATA.
NOTE:
For detailed operation procedures, refer to "Current Data Display For Engine". Ref. to
SUBARU SELECT MONITOR
.
|
Is the value of «VVT Adv. Ang. Amount R» approx. 0 deg, and the value of «OCV Duty R» approx. 10%? | Perform the following procedures, and clean the oil routing. Replace the engine oil and idle the engine for 5 minutes, and then replace the oil filter and engine oil. Ref. to REPLACEMENT , Engine Oil. Ref. to ENGINE OIL FILTER . | Check the following item and repair or replace if necessary.
|