DTC P0336 Crankshaft Position Sensor "A" Circuit Range/Performance: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION:
Detected when two consecutive driving cycles with fault occur.
TROUBLE SYMPTOM:
- Engine stalls.
- Failure of engine to start
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to
OPERATION
, Clear Memory Mode.>, and Inspection Mode <Ref. to
PROCEDURE
, Inspection Mode.>.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR. Turn the ignition switch to OFF. |
Is the crankshaft position sensor installation bolt tightened securely? | Go to step 2. | Tighten the crankshaft position sensor installation bolt securely. <Ref. to INSTALLATION , Crankshaft Position Sensor.> |
| 2 CHECK CRANKSHAFT PLATE. | Is there crack or damage in the crankshaft plate teeth? | Replace the crankshaft plate. | Go to step 3. |
| 3 CHECK INSTALLATION CONDITION OF TIMING CHAIN. Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block. ST 18252AA000 CRANKSHAFT SOCKET |
Is the timing chain dislocated from its proper position? | Correct the installation condition of timing chain. <Ref. to TIMING CHAIN ASSEMBLY .> | Replace the crankshaft position sensor. <Ref. to CRANKSHAFT POSITION SENSOR .> |