Oil Pressure Switch: Installation
WARNING: This page is about a different variant/trim than selected.
- Apply liquid gasket to the oil pressure switch threads.
Liquid gasket:
THREE BOND 1324 (Part No. 004403042) or equivalent
- Install the oil pressure switch to the oil pan upper.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Connect the terminal to the oil pressure switch.
- Install the under cover. Ref. to INSTALLATION , Front Under Cover.
- Lower the vehicle.
- Connect the ground terminal to battery sensor. Ref. to BATTERY
- Refill the engine oil. Ref. to REPLACEMENT , Engine Oil.