LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Emission Control Systems (Aux. Emission Control Devices) (H6DO)) >> Purge Control Solenoid Valve >> Installation

Purge Control Solenoid Valve: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the purge control solenoid valve, and connect the connector and vacuum hose to the purge control solenoid valve.
    NOTE: Connect the vacuum hose as shown in the figure.
    Fig 1: Connecting Vacuum Hose
    G11585890Courtesy of SUBARU OF AMERICA, INC.

    Tightening torque: 

    19 N.m (1.9 kgf-m, 14.0 ft-lb) 

  2. Install the air intake boot. <Ref. to INSTALLATION , Air Intake Boot.>
  3. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
  4. Install the collector cover.
scientia non olet · About LEMON Manuals