Rear Height Sensor: Removal
CAUTION:
Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.
Do not apply impact to the sensor assembly - headlight beam leveler or forcibly move the arm. Doing so may cause sensor damage and malfunction.
- Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
- Lift up the vehicle.
- Remove the rear wheel on the left side.
- Remove the sensor assembly - headlight beam leveler.
CAUTION:
Do not disassemble the sensor and lever.
- Disconnect the connector.
- Remove the nuts, and remove the sensor assembly - headlight beam leveler.