Inspection Without Using Can Diagnostic
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK BATTERY. Check the battery. <Ref. to INSPECTION , Battery.> <Ref. to INSPECTION , Battery.> |
Is the check result OK? | Go to step 2 . | Charge or replace the battery. |
| 2 CHECK FUSE. Check the fuse which might affect the problem. |
Is the check result OK? | Go to step 3 . | Replace the fuse. If the replaced fuse blows out easily, some type of fault is present. Therefore, repair the faulty portion. |
| 3 CHECK HARNESS. Check the harness and harness connector connection which might affect the problem. |
Is the check result OK? | In the Basic Diagnostic Procedure, Go to step 3 . | Repair or replace the faulty harness or harness connector. |