Diagnostic Method (Non-Turbo Model)
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
JUDGMENT VALUE SPECIFICATION
| Malfunction Criteria | Threshold Value |
|---|---|
| Diagnosis 1 | |
| |Measured turbine shaft speed - Measured primary pulley shaft speed| | > Table 1 RPM |
| Diagnosis 2 | |
| Measured turbine shaft speed | > 2000 RPM |
VEHICLE SPEED SPECIFICATION
| Vehicle speed (MPH) | 0 | 13 | 25 | 38 | 50 | 63 | 75 |
| |Measured turbine shaft speed - Measured primary pulley shaft speed| (RPM) | 150 | 100 | 100 | 100 | 100 | 100 | 100 |
| Vehicle speed (MPH) | 88 | 100 | 113 | 125 | 138 | 150 | 159 |
| |Measured turbine shaft speed - Measured primary pulley shaft speed| (RPM) | 100 | 100 | 100 | 100 | 100 | 100 | 100 |
Time needed for diagnosis: 5 seconds
Malfunction indicator light illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.