Execution Condition (Non-Turbo Model)
| Secondary Parameters | Execution condition |
|---|---|
| Diagnosis 1 | |
| 12 V battery system voltage | ≥ 10 V |
| Engine speed (The timer is held when the following conditions are not satisfied.) | > 600 RPM |
| Transmission range | Drive |
| Vehicle speed (calculated from measured secondary pulley shaft speed sensor) | ≥21.9 MPH |
| Diagnosis 2 | |
| 12 V battery system voltage | ≥ 10 V |
| Soak time (received from ECM) | ≥ 21600 s |
| (Engine speed for time)
NOTE:
The monitor detects TFT sensor stuck high after the elapse of 300 seconds required for ECT sensor diagnosis. It is necessary to avoid misdiagnosis of P0711 caused by a malfunctioning ECT sensor.
|
≥ 400 RPM ≥ 300 s |