LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle (Tr690) >> Transfer Clutch >> Installation

Transfer Clutch: Installation

  1. Apply CVTF to the seal ring and attach it to the seal ring groove of transfer clutch assembly.
    NOTE:
    • Use a new seal ring.
    • When installing the seal ring, do not expand the seal ring too much.
    Fig 1: Locating Transfer Clutch Assembly Seal Rings
    G06654512Courtesy of SUBARU OF AMERICA, INC.
  2. Install the transfer clutch assembly.
    Fig 2: Identifying Transfer Clutch Assembly
    G06654511Courtesy of SUBARU OF AMERICA, INC.
  3. Select the thrust needle bearing. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Rear Drive Shaft>ADJUSTMENT .
  4. Install the selected thrust needle bearing and needle bearing to transfer clutch assembly.
    NOTE: Install the thrust needle bearing in the correct direction.
    Fig 3: Installing Transfer Clutch Assembly Thrust Needle Bearing And Needle Bearing
    G06654499Courtesy of SUBARU OF AMERICA, INC.
  5. Install the rear drive shaft. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Rear Drive Shaft .
  6. Install the extension case. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Extension Case>INSTALLATION .
  7. Install the transmission assembly to the vehicle. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Automatic Transmission Assembly>INSTALLATION .
scientia non olet · About LEMON Manuals