Without DTC

Detecting condition:

Defective combination meter
Open circuit of harness

Trouble symptom:

The STEERING warning light will not turn off.
[No Diagnostic Code Present] will be displayed on Subaru Select Monitor.

NOTE: When the STEERING warning light is OFF and [No Diagnostic Code Present] is displayed on Subaru Select Monitor when all DTCs are read, the system is operating properly.

CHECK LAN SYSTEM.
Perform the diagnosis for LAN system using the Subaru Select Monitor. Ref. to LAN SYSTEM (DIAGNOSTICS)>Basic Diagnostic Procedure .

Is DTC U0131 detected?
- Yes : Perform the diagnosis according to DTC for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC) .
- No : Go to 2.
CHECK COMBINATION METER.
Check the STEERING warning light when the ignition switch is turned from OFF to ON.

Does the STEERING warning light illuminate at ignition switch ON, and turn off two seconds after the engine is started?
- Yes : Finish the diagnosis.
- No : Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter .