Power Steering Assist Enabled

Detecting condition:

Defective combination meter
Defective harness

Trouble symptom:

When the ignition switch is turned to ON (engine OFF), the STEERING warning light does not illuminate.

NOTE: It is operating normally if the warning light illuminates when the ignition switch is turned to ON (engine OFF), and turns off approximately two seconds after engine start.

CHECK ILLUMINATION OF OTHER LIGHTS.
Turn the ignition switch to ON. (Engine OFF)

Do other warning lights illuminate?
- Yes : Go to 2.
- No : Check the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter System>INSPECTION .
CHECK LAN SYSTEM.
Perform the diagnosis for LAN system using the Subaru Select Monitor. Ref. to LAN SYSTEM (DIAGNOSTICS)>Basic Diagnostic Procedure .

Is a DTC related to CAN communication detected?
- Yes : Perform the diagnosis according to DTC. Ref. to LAN SYSTEM (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC) .
- No : Go to 3.
CHECK COMBINATION METER.
Check the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter System>OPERATION>SELF-DIAGNOSIS DISPLAY MODE .

Is the check result OK?
- Yes : The combination meter is normal.
- No : Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter .