Seat Belt Outer - Rear RH & LH

Before installation, perform a unit inspection of retractor. Ref. to SEAT BELT SYSTEM>Rear Seat Belt>INSPECTION .
Install the seat belt outer - rear.
CAUTION:
- During installation, make sure that the seat belts are not twisted.
- After installation, make sure that the seat belts are smoothly extended and wound.
Tightening torque:

Refer to "COMPONENT" of "General Description".: Ref. to SEAT BELT SYSTEM>General Description>COMPONENT>REAR SEAT BELT .
Install the trim panel - rear quarter trim UPR.
Install the remaining parts in the reverse order of removal.
Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
After installation, check the following points.
- The seat belt is not twisted.
- The seat belt can be pulled out and retracted smoothly.