Seat Belt - Rear Shoulder Ctr
- Install the seat belt - rear shoulder CTR.
Tightening torque:
Refer to "COMPONENT" of "General Description".: Ref. to SEAT BELT SYSTEM>General Description>COMPONENT>REAR SEAT BELT .
- Install the remaining parts in the reverse order of removal.CAUTION:
- For installation of the stereo camera cover, refer to "INSTALLATION", "Stereo Camera Cover" in the "EyeSight" information and observe the precautions for installation. Ref. to EyeSight>Stereo Camera>INSTALLATION .
- For installation of the rod - power rear gate, refer to "INSTALLATION", "Power Rear Gate Rod" in the "POWER REAR GATE" information and observe the precautions for installation. Ref. to INSTALLATION .
- When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.
- Do not reuse the tether clip removed from the upper part of the trim panel - front pillar UPR. Always replace with a new part.
- Do not reuse the upper clips of the trim panel - center pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.
- Before installing the trim panel - front pillar UPR, check the condition of protective non-woven fabric (white) of the curtain airbag. If it is damaged (airbag module cloth is exposed), replace the curtain airbag module assembly with a new part.
NOTE: For installation of the trim panel - front pillar UPR, refer to "Upper Inner Trim". Ref. to EXTERIOR/INTERIOR TRIM>Upper Inner Trim>INSTALLATION . - Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
- After installation, check the following points.
- The seat belt is not twisted.
- The seat belt can be pulled out and retracted smoothly.