LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt System >> Rear Seat Belt >> Installation >> Seat Belt - Ctr RH And LH

Seat Belt - Ctr RH And LH

  1. Install the seat belt - CTR RH/LH.

    Tightening torque: 

    Refer to "COMPONENT" of "General Description".: Ref. to SEAT BELT SYSTEM>General Description>COMPONENT>REAR SEAT BELT .

  2. Install the rear seat cushion.
  3. Install the remaining parts in the reverse order of removal.
  4. Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
  5. After installation, check the following points.
    • The seat belt is not twisted.
    • Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON.
scientia non olet · About LEMON Manuals