LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Roll Connector >> Removal

Roll Connector: Removal

  1. Position the front wheels straight ahead. (After moving a vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead.)
  2. Turn the ignition switch to OFF.
  3. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>NOTE>BATTERY .
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  4. Remove the driver's airbag module. Ref. to AIRBAG SYSTEM>Driver's Airbag Module>REMOVAL .
  5. Remove the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>REMOVAL .
  6. Remove the cover assembly - column. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Column>REMOVAL .
  7. Remove the roll connector.
    CAUTION: Make sure that the roll connector is not turned from the original position.
    1. Disconnect the connector under the roll connector.
    2. Release the claws and remove the roll connector.
      Fig 1: Removing Roll Connector Claws
      G08316423Courtesy of SUBARU OF AMERICA, INC.
    3. Release the claws and separate the roll connector (a) and steering angle sensor (b).
Fig 2: Identifying Roll Connector And Steering Angle Sensor Claws
G08316424Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals