Sunload Sensor (Auto A/C Model): Inspection

Check if there is anything that affects sensing, around the sunload sensor.
1. Is the sunload sensor free from any object that disturbs sensing?
2. Is the windshield glass free from any object such as sticker or film that disturbs sensing?
  - Yes → Go to step 2.
  - No → Remove everything that affects sensing.
Check the [Quantity of Sunload] using Subaru Select Monitor.
NOTE: For detailed operation procedures, refer to "Application help".
1. On [Start] display, select [Diagnosis].
2. On [Vehicle selection] display, enter vehicle information and select [OK].
3. On [Main Menu] display, select [Each System].
4. On [Select System] display, select [Air Conditioner], and then select [Enter].
5. On [Select Function] display, select [Data monitor].
6. From the data monitor item list, select [Quantity of Sunload].
7. Cover the sunload sensor with cloth.
8. Does the [Quantity of Sunload] indicate 0 W/m² when the direct sunlight is shielded?
  - Yes → Go to step 3).
  - No → Replace the sunload sensor.
From step 2, expose the sunload sensor to light.
1. Place intense light such as incandescent light at 300 mm (11.81 in) or less from the sunload sensor.
2. Does [Quantity of Sunload] indicate 2, 000 W/m² or less?
  CAUTION: The value changes depending on the angle of light.
  - Yes → The sunload sensor is normal.
  - No → Replace the sunload sensor.