In-Vehicle Sensor (Auto A/C Model): Removal

CAUTION: Be careful not to damage the sensors and interior trims when removing.

1. Disconnect the ground cable from battery. Ref. to NOTE>NOTE>BATTERY .
   NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
2. Remove the cover assembly - instrument panel LWR driver INN. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
3. Remove the in-vehicle sensor.
   1. Disconnect the connector, and remove the aspirator hose.
      Fig 1: Removing Aspirator Hose Connector

      Courtesy of SUBARU OF AMERICA, INC.
   2. Release the claws and remove the cover switch - starter.
   3. Remove the screw and remove the in-vehicle sensor from the cover switch - starter.

Fig 2: Locating Starter Cover Switch Screw

Courtesy of SUBARU OF AMERICA, INC.