Blower Resistor (Manual A/C Model): Removal

1. Disconnect the ground cable from battery. Ref. to NOTE>NOTE>BATTERY .
   NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
2. Remove the glove box. Ref. to EXTERIOR/INTERIOR TRIM>Glove Box>REMOVAL .
3. Remove the engine control module (ECM). (Non-turbo model) Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Engine Control Module (ECM)>REMOVAL .
4. Remove the resistor.
   1. Disconnect the connector.
   2. Remove the screw and remove the resistor.

Fig 1: Locating Blower Resistor Connector (Manual A/C Model)

Courtesy of SUBARU OF AMERICA, INC.