When Switched To X Mode, "S", "I", "S#" Or "X" Mode Display In Combination Meter Flashes

1. Start the engine.
2. Check if malfunction indicator light illuminates.

Does the malfunction indicator light illuminate?

1. Yes  : Read the DTC using Subaru Select Monitor and check the indicated DTC. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Read Diagnostic Trouble Code (DTC) . Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Read Diagnostic Trouble Code (DTC) .
2. No  : Go to 2. 

1. Turn the ignition switch to ON.
2. Check the coolant temperature warning light.

Does it indicate overheating?

1. Yes  : Inspect for the cause of overheating and repair.
2. No  : Go to 3. 

1. Turn the ignition switch to ON.
2. Check the value of Oil Temperature using Subaru Select Monitor.
   NOTE: For detailed operation procedures, refer to "Current Data Display For Engine". Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Subaru Select Monitor . Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Subaru Select Monitor .

Is the value of Oil Temperature 117°C (243°F) or more?

1. Yes  : Inspect and repair the cause of engine oil temperature rise.
   NOTE: Ask the customer whether the vehicle has experienced a long drive in low gear or towing of heavy load. If not, drive the vehicle after the engine oil temperature lowers, and check if the engine oil temperature rises.
2. No  : Go to 4. 

1. Start the engine.
2. Switch to X mode.
3. Check X mode display in the combination meter.

Does "S", "I", "S#" or "X" display in the combination meter flash?

1. Yes  : Replace the meter case assembly. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter .
2. No  : Perform test operation and check the malfunction indicator light, engine coolant temperature warning light, and engine oil temperature. If they are normal, finish the diagnosis.