When Switched To X Mode, "S", "I", "S#" Or "X" Mode Display In Combination Meter Flashes In Approx. 5 Seconds

WARNING: This page is about a different variant/trim than selected.

CHECK DTC.
Is DTC displayed?
1. Yes : Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)" concerning the respective units.
2. No : Go to 2.
CHECK COMBINATION METER AND CLOCK DISPLAY.
Check for abnormal displays other than "S", "I", "S#" or "X" flashing.

Examples:
- Malfunction indicator light illuminates.
- Fuel economy display area is not ON.
NOTE: The system enters into fail mode with ignition ON and engine OFF.

Is there an abnormal display other than "S", "I", "S#" or "X" flashing?
1. Yes : For the diagnostic procedure, refer to LAN article. Ref. to LAN SYSTEM (DIAGNOSTICS)>Basic Diagnostic Procedure .
2. No : Go to 3.
CHECK ECM AND COMBINATION METER.
Is the part number of ECM and combination meter correct?
1. Yes : Replace the meter case assembly. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter .
2. No : Replace ECM or meter case assembly with the one with the correct part number. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Engine Control Module (ECM) . Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Engine Control Module (ECM) . Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter .