Reverse Brake Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the snap ring.
Remove the retaining plate, drive plate, driven plate and dish plate.

Fig 1: Removing Retaining Plate, Drive Plate, Driven Plate And Dish Plate
Courtesy of SUBARU OF AMERICA, INC.
Compress the return spring using the ST to remove the snap ring.
ST 18762AA001 COMPRESSOR SPECIAL TOOL

Fig 2: Compressing Return Spring Using ST
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, remove the snap ring and spring retainer.

Fig 3: Removing Snap Ring And Spring Retainer
Courtesy of SUBARU OF AMERICA, INC.
Remove the return spring.

Fig 4: Removing Return Spring
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse brake piston by blowing compressed air intermittently from reverse brake housing hole.

Fig 5: Locating Reverse Brake Housing Hole
Courtesy of SUBARU OF AMERICA, INC.