General Tool
WARNING: This page is about a different variant/trim than selected.
| TOOL NAME | REMARKS |
|---|---|
| Circuit tester | Used for measuring resistance, voltage and current. |
| Thickness gauge | Used for measuring the clearance in reverse brake, forward clutch and transfer clutch. |
| Caliper | Used for measuring the dimension. |
| Spring scale | Used for measuring the starting torque of the drive pinion. |
| TORX® bit T40 | Used for removing and installing the secondary pressure (line pressure) test plug and plug. |
| TORX® bit T70 | Used for removing and installing differential gear oil drain plug. |
| STRAIGHT PIN REMOVER | Used for removing and installing the straight pin and spring pin. |
| Push/pull gauge | Used for measuring clutch clearance. |
| Angle gauge | Used for installing the drive plate. |
| TONE 3/8 6-point 27 mm deep socket (manufacturer product No. 3SEN-27) | Used for removing and installing the secondary pressure sensor. |
| DST-i | Used together with Subaru Select Monitor 4. |